Characterization of turn-on time delay in a fiber grating fabry-perot lasers
In this paper, turn-on time delay characteristics of a fiber grating Fabry-Perot (FGFP) laser are numerically investigated by considering all the carrier recombination rate (CRR) R(N) coefficients (nonradiative, A(nr); radiative, B; and Auger coefficient, C). The results show that the turn-on time d...
Saved in:
| Main Authors: | , , , , |
|---|---|
| Format: | Article |
| Published: |
Institute of Electrical and Electronics Engineers (IEEE)
2012
|
| Subjects: | |
| Online Access: | http://eprints.um.edu.my/4643/ http://eprints.um.edu.my/4643/1/Hisham%2D2012%2DCharacterization_of.pdf |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | In this paper, turn-on time delay characteristics of a fiber grating Fabry-Perot (FGFP) laser are numerically investigated by considering all the carrier recombination rate (CRR) R(N) coefficients (nonradiative, A(nr); radiative, B; and Auger coefficient, C). The results show that the turn-on time delay significantly reduces by increasing the injection current (I-inj) and/or the initial value of carrier density (N-i). Meanwhile, the turn-on time delay increases by increasing the CRR coefficients. However, its effect can be minimized by increasing I-inj and/or N-i. In addition, the turn-on time delay can be reduced by increasing the external optical feedback (OFB) level. Moreover, it is shown that the optimum external-cavity length (L-ext) is 3.1 cm. Furthermore, an antireflection (AR) coating reflectivity value of 1 X 10(-2) is sufficient for the laser to operate at good turn-on time delay and low fabrication complexity. The obtained results can provide an important idea for the practical fabrication of the FGFP laser used in the dense wavelength-division multiplexing (DWDM) systems and optical access networks. |
|---|