உருவ மூடி

Mold design for plastics injection molding process (two colors) and analysis of gates location

This thesis describe about the mold design for plastic injection molding process for two colors and the analysis of gate location in order to find the best gate location to apply it in to the design. The molds for injection molding is not the cheap one it is expensive and needed an accurate step whe...

முழு விளக்கம்

Saved in:
நூற்பட்டியல் விவரங்கள்
தலைமை எழுத்தாளர்: Ahmad Zulhelmi, Muhamad
வடிவம்: Undergraduates Project Papers
வெளியீடப்பட்டது: 2009
பகுதிகள்:
TP Chemical technology
நிகழ்நிலை அணுகல்:http://iportal.ump.edu.my/lib/item?id=chamo:45504&theme=UMP2
http://iportal.ump.edu.my/lib/item?id=chamo:45504&theme=UMP2
http://umpir.ump.edu.my/16862/1/Mold%20design%20for%20plastics%20injection%20molding%20process%20%28two%20colors%29%20and%20analysis%20of%20gates%20location-Table%20of%20contents.pdf
http://umpir.ump.edu.my/16862/25/Mold%20design%20for%20plastics%20injection%20molding%20process%20%28two%20colors%29%20and%20analysis%20of%20gates%20location%20-%20Abstract.pdf
http://umpir.ump.edu.my/16862/13/Mold%20design%20for%20plastics%20injection%20molding%20process%20%28two%20colors%29%20and%20analysis%20of%20gates%20location-Chapter%201.pdf
http://umpir.ump.edu.my/16862/19/Mold%20design%20for%20plastics%20injection%20molding%20process%20%28two%20colors%29%20and%20analysis%20of%20gates%20location-References.pdf
குறியீடுகள்: குறிச்சொல் இணை
குறியீடுகள் இல்லை, இந்த குறிச்சொல்லை முதலில் பதிவு செய்யுங்கள்!

இதே போன்ற பொருட்கள்