உருவ மூடி

Effects of TiO2 addition on the phase, mechanical properties, and microstructure of zirconia-toughened alumina ceramic composite

Ceramic composite made up of zirconia-toughened alumina (ZTA) with TiO2 as additive was constructed via a solid-state sintering route. The Vickers hardness of the obtained ZTA-TiO2 was evaluated at various levels of the TiO2 addition. Every sample was dry mixed, uniaxially pressed and sintered at 16...

முழு விளக்கம்

Saved in:
நூற்பட்டியல் விவரங்கள்
தலைமை எழுத்தாளர்கள்: Manshor, Hanisah, Md. Aris, Suriyana, Ahmad Azhar, Ahmad Zahirani, Chan Abdullah, Ezzat, Ahmad, Zainal Arifin
வடிவம்: கட்டுரை
வெளியீடப்பட்டது: 2015
பகுதிகள்:
A General Works
நிகழ்நிலை அணுகல்:http://eprints.utm.my/58441/
http://eprints.utm.my/58441/
குறியீடுகள்: குறிச்சொல் இணை
குறியீடுகள் இல்லை, இந்த குறிச்சொல்லை முதலில் பதிவு செய்யுங்கள்!
விளக்கம்
தொகுப்பு:Ceramic composite made up of zirconia-toughened alumina (ZTA) with TiO2 as additive was constructed via a solid-state sintering route. The Vickers hardness of the obtained ZTA-TiO2 was evaluated at various levels of the TiO2 addition. Every sample was dry mixed, uniaxially pressed and sintered at 1600 °C for 1 h in a pressureless condition. The presence of TiO2 was observed to have greatly influenced the microstructure of the Al2O3. Grain growth of the Al2O3 particles was hindered with the addition of 3 wt% TiO2, but increased in size at an excess of 3 wt% TiO2. According to the results, tialite (Al2TiO5) begun appearing at a composition of ZTA-5 wt% TiO2 and this increased with the TiO2 content. The fracture toughness and hardness were enhanced from 5.93 MPa m (0 wt% TiO2) to 6.56 MPam (3.0 wt% TiO2) and from 1516.13 HV (0 wt% TiO2) to 1615.8 HV (3.0 wt% TiO2), respectively. The improved bulk density from 3.9 g/cm3 (0 wt% TiO2) to 4.10 g/cm3 (3.0 wt% TiO2) resulted from the fine microstructure, thereby enhancing the mechanical properties.

இதே போன்ற பொருட்கள்